Get help with your car nowAsk a professional

 Some people will tell you that flushing your power steering fluid is a waste of time and money. Well, I have been in the automotive business for many years and I will tell you that flushing the power steering system is a must. True, it may not have to be done often, but depending on your driving conditions it may. Just like any other fluid, over time it will break down, and if you ever have to replace your power steering rack because of fluid breakdown, you will become a quick believer. Flush your power steering fluid!!!!!!

Things You'll Need:

Hose

Empty container

Car jack

Assorted hand tools depending on make of vehicle

Manufacturer recommended fluid

 1:  Put your car in park and turn off the engine.

2:   Open your car's hood. Secure it in place so you can work beneath it.

3:    Remove the filter from the top of your power steering system. For the exact location of your car's power steering filter, you'll need to consult your owner's manual.

4:    Detach the overflow tank from the radiator. This will make it easier for you to reach the power steering reservoir. Keep the tank handy, as you'll be replacing it soon.

5:    Disconnect the reservoir's hose. It should be located on the bottom of the reservoir. The hose can be tough to remove, so make sure you have plenty of patience.

6:    Replace the reservoir's hose with another hose. It should lead to an empty container. You'll use this container to store the old power steering fluid as it leaves the reservoir

7:    Lift the front end of your car off the ground by using a car jack.

8:    Add new power steering fluid to the reservoir. As you add the new lubricant, it will force the old lubricant into the tube you've connected to the bottom of the reservoir.

9:    Climb into the drivers seat and rack your steering wheel back and forth. The wheel should be locked in place, allowing only a slight range of mobility. This will help the extra lubricant within the power steering system to drain.

10:   Watch the empty container. It should fill with old lubricant. Once the old lubricant has been flushed and you see clean fluid replacing it, you've finished the hard part.

11:   Disconnect your hose and move the container.

12:   Replace the original reservoir hose.

13:   Pour new, clean power steering fluid into the reservoir.

14:   Rack your steering wheel a few more times to squeeze out air that might be trapped in the lines.

15:   Replace the filter and overflow tank and close your hood.


AutoPartsEXPRESS 468x60

 Tips & Warnings


You may have to flush your power steering system if the lubricant has become contaminated by dirt or debris. A modest amount of debris is expected to collect while driving, but excessive amounts can lead to other problems with your steering system.

A well-maintained car can expect to go 200,000 miles before it needs to have the power steering fluid replaced. Unless you're suffering from a mechanical problem, drive excessively or drive in extreme weather, you should only need to flush your power steering fluid roughly four times per century.

Once you flush your power steering fluid, it's important that you replace it with another lubricant specifically designed for use within a power steering system. While less expensive, generic lubricants exist, they can cause damage the rubber inside your car's steering mechanism. Consult your car's owner's manual for specific instructions as to the kinds of steering fluid that are safe to use.

Steering fluid is meant to look dirty. Often times, steering fluid will turn dark and murky within minutes of being added. You might not be able to tell whether your steering fluid needs to be changed just by looking at it.


Don't forget to visit our blog